EasyManua.ls Logo

Symphony SA-160 - 8.3 Inspection Periods

Default Icon
338 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SA 160
AIRCRAFTA I R C R A F T
Symphony
AIRCRAFT
8.3 INSPECTION PERIODS
Symphony Aircraft Industries Inc. has developed an Inspection Time
Interval Chart for the SA 160. This chart, provided by SAI, recommends
inspection items and time intervals (e.g. 50, 100, 200 hours). Inspections
requirementsareprovidedintheSA160MaintenanceManualChapter5.
As required by the airworthiness regulations, all civil aircraft must
undergo a complete inspection each twelve calendar months (annual),
and in addition to this inspection, aircraft operated commercially (for
hire) must have a complete inspection every 100 hours of operation in
order to keep the Certificate of Airworthiness in effect. Applicable
inspection items for 100 hrs or annual inspection are specified by the
airworthiness authorityoftherespectiveSA160owners.
The SA 160 Inspection Time Intervals Chart should be used as specific
augmentation, but it is not intended to be utilized as the primary
checklistforinspectionoftheaircraft.
The required inspections should be accomplished by a properly trained
and qualified mechanic of an authorized SAI Service Station. SAI will not
accept responsibility for the continued airworthiness of an aircraft not
maintained to these standards, and / or not brought into compliance with
applicable Service Bulletins issued by SAI instructions issued by the
engine, propeller, or accessory manufacturers, or Airworthiness
DirectivesissuedbythenationalAirworthiness Authority
8.5 PREVENTIVE MAINTENANCE
Acertified pilot who owns or operates an aircraft not usedas an air carrier
may be authorized by its local airworthiness authority to perform limited
preventive maintenance. Please refer to the specific local airworthiness
authority to determine specific maintenance procedures, which are
allowed.
SECTION 8
GROUND HANDLING, SERVICING & MAINTENANCE
8-4
Feb 25, 2005

Table of Contents