AIRCRAFT
SA 160
AIRCRAFTA I R C R A F T
Symphony
(2)Makesure that the BAT switch is in OFF position.
(3)Ensure fire fighting equipment is positioned and immediately
available.
(4)Groundtheaircraftandfillingdeviceasrequired.
(5) Place a suitable ladder to achieve easily the fuel filler caps on the
topofwings.
(6) Fuel aircraft. Ensure approved grade of aviation fuel is used.
(a) Remove the fuel cap and fill left tank to the desired level.
Install fuel cap.
(b) Remove the fuel cap and fill right tank to the desired level.
Install fuel cap.
(7) Check correct lock of both fuel filler caps. Remove excess fuel
from wing area using a cloth.
(8) Remove ground cables.
(9) Compare reading of fueled amount on filling device with
reading on the fuel indicator in the aircraft.
The operation of the aircraft with an anti-freezing additive is
approved. When anti-freezing additive is used, it must meet the
specification MIL-I-27686. It should be blended uniformly with fuel
while refueling and should not exceed 0.15% by volume of refueled
quantity, and for effectiveness it should be blended at no less than
0.10% by volume. For example 42,6 ccm (1,5 fl.oz.) anti-freezing
additive per 38 Liters (10 U.S. Gallons) fuel would fall in this range.
Use only blending equipment that is recommended by the
manufacturer to obtain proper fuel mixing ratio. In addition to the
information in this section, the manufacturer's blending instructions
shouldbeused.
Additives
SECTION 8
GROUND HANDLING, SERVICING & MAINTENANCE
Feb 25, 2005
8-11
To Next Page
Loading...