Tait TP9100 - Page 122

122 Disassembly and Reassembly TP9100 Service Manual
© Tait Electronics Limited May 2005
Fitting the
Main-Shield
Assembly
The circled numbers in this section refer to the items in Figure 5.15 on
page 121.
1. Open the lock of the front-panel interface connector [
PL2] at the
bottom of the main board
F.
2. Use rubber-nose pliers to carefully insert the end of the front-panel
loom labelled “RADIO” into the connector.
3. Make sure that the loom is correctly seated, and lock the connector.
4. To fit the main-shield assembly
D to the chassis I:
a. Start at the top by sliding the two locating holes of the main-shield
assembly over the two locating pins of the chassis.
b. Snap-fit the bottom of the main-shield assembly into place.
5. Fit the two speaker pin frames
C over the speaker pins, with the
horizontal part of the speaker pin frames facing upwards.
6. Place the LCD frame
B in position over the LCD assembly and the
main-shield assembly.