Tait TP9100 - Page 131

TP9100 Service Manual Servicing Procedures 131
© Tait Electronics Limited May 2005
Tas k 8 —
Check
Error Messages
If the radio displays shows an error message, carry out the corrective actions
described in Table 6.1.
Table 6.1 Error messages
Error message Corrective action
Error E0001
Unknown
Turn the radio off and then back on
Error E0002
Unknown
Continue with servicing tasks to locate the problem
Error E0003
Corrupt FW
Re-download the radio’s firmware
Error E0008
System error
0xabcdefgh
Turn the radio off and then back on. If the system error persists, download new
radio firmware
To capture details of the system error, use CCTM command
204
Error E0015
Battery error
Replace the battery
Error E0016
Battery error
Replace the battery
Temperature threshold
exceeded
Wait until the radio has cooled down
Cannot tx Go to Task 9 on page 132
Battery is flat Recharge the battery
Unsafe battery Replace the battery
Discharge battery Discharge then recharge the battery
Programming mode,
invalid radio ...
Re-program the radio with a new programming database. If the problem persists,
update or reload the radio’s firmware, and re-program the radio’s calibration
database.