Tait TP9100 - Page 82

82 General Information TP9100 Service Manual
© Tait Electronics Limited May 2005
Service Kit
The service kit contains all the items needed for connecting the radio to the
test equipment. The setting up of the equipment is described in “Test
Equipment Setup” on page 86. The service kit also includes a service CD
and a folder with the necessary service documentation, including this
manual. The CD contains the programming application, calibration
application, and soft-copies of the service and related documentation.
The contents of the service kit are listed in Table 4.2.
Note The characters xx below stand for the issue number of the manual.
Only the latest issue of each manual will normally be available for
ordering.
Table 4.2 Contents of service kit (TMAA24-00)
Product code Item
TOPA-SV-006 RF cable
TPA-SV-005 Battery eliminator (power supply adaptor)
TPA-SV-007 Programming cable adapter(RJ12 socket to TP9100)
TPA-SV-011 Calibration cable (DB15 socket to TP9100)
TPA-SV-006 Programming cable (DB9 socket to RJ12 plug)
T950-001 USB to serial adapter (USB1.1 to serial DB9 pin)
TOPA-SV-024 Test unit
TOPA-SV-011 Service tools (including the modified 3/16 inch (8 mm) long-reach socket bit)
MPA-00005-xx Service manual
MPA-00011-xx PCB information
TMAA24-01 Service CD
The following components are included in the service kit, but are used for TM9100 mobile radios only:
TMAA21-01 Calibration cable (DB15 socket to RJ45 plug plus speaker connector)
TMAA23-02 Power cable (40W/50W power connector to banana plugs plus speaker connector)
TMAA20-03 Power cable (25W power connector to banana plugs plus speaker connector)
TMAA20-04 Programming cable (RJ12 socket to RJ45 plug)
MMA-00017-xx Service manual
MMA-00026-xx PCB information