Tait TP9400 User Manual

66 Operating in P25 trunking mode
Service is lost
If access to the trunking system is lost, no longer
appears, the bars in the RSSI icon disappear
, and the
display shows No service.
The radio sounds five beeps to indicate the loss of
service, followed by a repeating double beep. The
double beep continues until service is restored.
Site trunking operation
During normal trunking operation, your radio may roam
between a number of sites, each with its own zone
controller. This behavior is transparent to you, unless
there is a problem with a zone controller. When this
happens, the radio enters ‘site trunking’ mode, and you
will only be able to communicate with users within a
single site.
While in site trunking mode, the display shows Site
Trunking, and the radio sounds a repeating double
beep. The double beep continues until normal service
is restored.
When access to the zone controller is available again,
your radio automatically returns to normal multi-site
operation.
Failsoft operation
Your radio may be programmed to enter ‘failsoft’ mode
when service is lost due to failure of a trunking site
controller. For information about failsoft mode, see
“Failsoft mode operation” on page 76.
Talkgroup 1
No service
Menu
Site Trunking
Zone 11
Menu

Tait TP9400 Specifications

General

Battery Type	Li-Ion
Digital Protocol	DMR Tier II
Channel Spacing	12.5 kHz, 25 kHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4 V
Channels	1000