Tait TP9400 User Manual

Operating in P25 trunking mode 75
Unconnected calls
If your call is not connected, the way your radio behaves
is explained in the following table.
Radio behavior Explanation
The system is too busy to process
your talkgroup or individual call.
The radio sounds
three short beeps.
The system is now available to
process your talkgroup or
individual call.
The radio sounds five
beeps, followed by a
repeating double
beep.
You have selected a talkgroup that
does not currently exist on the
system. Your display shows that
you have lost service and no
longer appears.
See “Service is lost” on page 66.
The radio sounds two
short beeps.
You have attempted to make an
individual call to a radio that does
not currently exist on the system.
You have attempted to make an
individual or phone call, but you are
not authorized to do this.
The radio sounds two
short beeps.
Your individual or phone call has
been rejected or is unanswered.
System
queued
Busy channel
now free
Talkgroup 1
No service
Menu
No answer
No answer

Tait TP9400 Specifications

General

Battery Type	Li-Ion
Digital Protocol	DMR Tier II
Channel Spacing	12.5 kHz, 25 kHz
Operating Temperature	-30°C to +60°C (-22°F to +140°F)
Operating Voltage	7.4 V
Channels	1000