28 Before using your radio
Removing a belt clip
The belt clip has been designed to prevent accidental
removal, but you can take it off, if required.
To remove a belt clip from a battery:
1 Insert a flat screwdriver blade or similar flat object
under the lip of the release lock (that is, between it
and the metal slider).
2 Lift the release lock up (away from the metal slider)
and hold it in position.
3 Slide the belt clip out.
Installing an accessory
Accessories plug into the radio’s accessory connector.
The accessory connector is protected by a cover, which
needs to be removed before an accessory can be
installed.
Notice The accessory cover protects the accessory
connector from electrostatic discharge. Keep the cover
in place unless the connector is in use.
To remove the accessory cover and install an accessory:
1 Use a coin or other blunt object to loosen the screw
that secures the accessory cover to the radio.
2 Remove the accessory cover and store it in a safe
place.
3 Plug the accessory into the accessory connector.
4 Tighten the screw.
To Next Page
Loading...
Need help?
General
