Before using your radio 27
Removing the battery
The battery is secured to the radio by a battery catch in
the radio’s rear panel.
To remove the battery from the radio, so that the battery
can be charged or replaced:
1 Slide the battery catch up.
2 From the sides, pull the battery away from the radio.
Attaching the antenna
Before using the radio, screw the antenna clockwise into
the antenna connector. The antenna should be screwed
sufficiently tight so that it doesn’t unscrew easily.
Before using the radio, screw the antenna clockwise
into the antenna connector. The antenna should be
screwed sufficiently tight so that it does not unscrew
easily. This is important as it creates a seal.
Removing the antenna
Use a firm grip and turn the antenna counterclockwise
half a turn. Use a lighter grip to fully unscrew the
antenna, and carefully remove it.
Attaching a belt clip
To attach a belt clip to the radio:
1 Slide the belt clip into the two grooves at the top of
the battery.
2 Press down on the belt clip until it snaps into place.
To Next Page
Loading...
Need help?
General
