When the battery is completely empty, the message Battery is flat appears on the display. The radio emits a long,
low-pitched beep and then turns off. Turnoff the radio.
Inserting the Radio into the Vehicle Charger
1. Place the radio in the charger with the battery attached.
When the portable radio is used inside a vehicle, radio performance is degraded.
Use a mobile radio for all critical communications. If the portable radio must be left
switched on while it is in the charger, removing the radio from the charger will
improve radio performance. Check your local regulations about using a portable
radio in a vehicle.
2. Firmly press the retention bar towards the radio.
Ifthe larger battery is attached to the radio, there will be an audible click as the catches engage. If the
smaller battery is attached to the radio, there will be two audible clicks as the catches engage. Ifthe
catches do not engage, remove the radio. Pressonce firmly on the release bar, then try again.
Charging a Battery
Charging a Battery for the First Time
Fully charge a battery before using it for the first time.
The red LED stays lit while the battery charges.
Charging a Battery
Notice For best charging performance, switch off the radio before placing it in the charger (not for bat-
tery-only vehicle charger).
• Desktop charger: Connect the charger to the correct Tait power adaptor.
• 6-way charger and vehicle charger: Poweronthecharger.
Initially, all three LEDs are lit for 2 seconds.
95
Tait International Ltd July 2021
To Next Page
Loading...
Need help?
General
