Tait offers custom labelling for TP9600 P25 Portable Radios. Contact your Tait representative for
more information.
Charging the battery before first use
Before using the battery for the first time, it must be charged. Follow the instructions included with your Tait๎charger.
This information is repeated in the section "Charging and Caring for Batteries" on page๎1.
For best charging performance, switch off the radio before placing it in the charger.
See Charging and Caring for Batteries for detailed instructions on how to charge your battery.
Li-ion batteries
Fully charge a Li-ion battery before using it for the first time. This will take up to 3 hours. It is not necessary to prime a
Li-ion battery.
Attaching the battery
Use only genuine Tait manufactured batteries with Tait radios. Fitting a battery
that is not Tait-approved may damage the radio or cause harm.
Notice Fit the bottom edge of the battery to the radio, then the top edge. Attempting to fit the top edge
first may damage the contacts.
1. Rotate the power/volume control switch counterclockwise to turn off the radio.
If the battery has been attached while the radio is turned on, turn the radio off and then on again before
use.
2. Holding the radio firmly, align the back of the battery with the back of the chassis.
3. Place the two lugs at the bottom edge of the battery into the two slots in the bottom of the front panel.
4. Lightly press the top of the battery towards the radio until the battery catch clicks.
5. Make sure that the battery is firmly in position.
20
Tait International Ltd July 2021
To Next Page
Loading...
Need help?
General
