EVERY CALL COUNTS 13
VLAN ID (PC)
The VLAN ID (PC) assigns the identification for Ethernet frames for the phone PC port. Setting the VLAN ID
to zero (0) disables VLAN framing and the phone will only use standard Ethernet frames.
To assign the VLAN ID (PC) port:
• Press the button, then select 1. Network Configuration, 8. VLAN Settings.
•Select 4. VLAN ID (PC).
• Input the VLAN ID (PC) port using the dial pad and press the OK
softkey to save your entry.
CDP
The TS-350i can be assigned to employ the Cisco® Discovery Protocol to determine if VLANs are to be used
and the associated VLAN ID. The CDP selection displays only if function_cdp is enabled in the
configuration file. As a default, the CDP parameter is disabled since TalkSwitch does not use VLAN tagging.
To set the CDP status:
• Press the button, then select 1. Network Configuration, then 9. CDP
• Select the desired softkey (Yes or No) to enable or disable CDP.
Changing the VLAN ID (PC) requires a reboot of the phone. When you exit the menu, you will receive a reboot notice.
To disable VLANs, assign the VLAN ID as zero (0).
Changing the CDP status requires a reboot of the phone. When you leave the menu, you will receive a reboot notice.
When CDP is enabled, VLAN settings are overwritten.
To Next Page
Loading...
