20
nOnlIn-2
Differences are more pronounced with low Diffuse
settings and Twist Ratios.
Diffuse
Range: 0 - 100%
Sets the amount of diffusion applied to the Reverb Style
selected.
ForhighDiffuseratios,theAttackandDecaytimes
ofthereverbEnvelopemaybeslightlyaffected.
Twist Type
Selectswhichtypeoffunkyeffecttreatmenttobeused
on the reverb. Twist Type should be regarded as a spice
capableofsparkingimaginationinthemixprocess.Trythe
effect on all sorts of different sources to add character or
makethemstandout.IfspectralshapingusingtheTwist
parameters get out of control, the Lo and Hi cuts can be
used to stay within limits.
When the Twist Ratio is set at 0%, Twist Type has
no effect.
Twist Ratio
Range: 0 - 100%
Appliestheselectedamountof“Twist”totheReverb.
When the Twist Ratio is set at 0%, Twist Type has
no effect.
Width
Range: 0 - 100%
AdjuststheOutputStereoWidth.0%denotesmono,while
100% is max width.
The perceived width of the effect is also affected
by the Reverb Style and Diffuse parameters. Width
difference between Styles is most obvious at low
Diffuse Ratios.
Levels page
In Level
Range: Off - 0dB
Adjuststheinputlevel.
If radical Style and Twist settings are used, or full
scaleInputsignals,itmaybenecessarytoadjust
the Input level slightly down to avoid overloading the
Outputs. Overloads are shown as a red indication
abovetheEnginenumberontopofthescreen.
High resolution internal processing ensures that
audio quality is not affected, should headroom
adjustmentsbenecessary.
Out Level
Range: Off - 0dB
AdjuststheOutputlevel.
Dry Level
Range: Off - 0dB
AdjuststhedrysignallevelpassedthroughtheEngine.
Foratypicalsend/returnconfiguration,leaveDryleveloff.
Wet Level
Range: Off - 0dB
AdjuststhewetOutputlevel.
Lo Cut
Range:20Hzto20kHz
Lo Cut on the Reverb Input.
Hi Cut
Range:20Hzto20kHz
Hi cut on the Reverb Input.
LoandHiCutcanhelpkeepingheavilyTwisted
processing better under control.