EasyManuals Logo

TC Electronic SYSTEM 6000 MKII Algorithm Manual

TC Electronic SYSTEM 6000 MKII
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
vss™3
VSS™3
TheVSS™3ReverbalgorithmincorporatesdedicatedEarly
Reflection types for motion picture use, e.g. Car, Bathroom
and Conference Rooms.
The VSS-3 algorithm occupies:
@ Normal Sample Rate : 1/4 DSP Resource
@ Double Sample Rate : 1/4 DSP Resource
Algorithm Inputs/Outputs are distributed as follows:
Main
Decay
Range: 0.01 to 20s
TheDecaytimeoftheReverb.Usuallyassociatedwiththe
timeittakestheReverbTailtodecay60dB.Thisisthe
overall Master Decay for the four band Decay parameters
(foundintheREVERBsectionbelow)whicharemultiples
of this base Reverb time.
Rev Delay
Range: 0 - 200ms
A delay to the diffuse field part of the Reverb.
AddsadditionaltimebetweentheEarlyReflectionsandthe
onsetofthe“diffusefield”oftheReverb.
Pre Delay
Range: 0 to 100ms
A delay placed at the Input of the algorithm. This sets how
longafterthedrysoundtheEarlyReflectionsandthe
diffuse field will begin.
Hi Cut
Range:20to20kHz
Rolls off the top end as it enters the Reverb.
UsedinconjunctionwithHiSoftenandHiDecayto
“darken”aroom.
Hi Decay
Sets the Decay time for the High-end frequencies of the
Reverb diffuse field.
Levels
Rev Level
Range: -100dB to 0dB
The Output level of the diffuse field part of the algorithm
When Rev Level is set to off, the effect will consist entirely
ofEarlyReflections.
Early Level
Range: -100dB to 0dB
TheOutputleveloftheEarlyReflections.WhenEarlyLev
is set to off the Reverb effect will consist entirely of Reverb
“Tail”.
Dry Level
Range: Off to 0dB
Attenuates the Dry signal level on the Output side thus
leavingtheReverbandEarlyLevelunaffected.Offequals
a“kill-dry”setting.
In Level
Range: Off to 0dB
Sets the In Level for the algorithm.
Out Level
Range: -100dB to 0dB
The overall Output level of the Reverb. This is mostly used
whenthealgorithmsusedinSerialwithotherEngines.
E1 - E4
S1
S2
L
R
INPUT
OUTPUT

Other manuals for TC Electronic SYSTEM 6000 MKII

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TC Electronic SYSTEM 6000 MKII and is the answer not in the manual?

TC Electronic SYSTEM 6000 MKII Specifications

General IconGeneral
BrandTC Electronic
ModelSYSTEM 6000 MKII
CategoryComputer Hardware
LanguageEnglish

Related product manuals