EasyManuals Logo

TC Electronic SYSTEM 6000 MKII Algorithm Manual

TC Electronic SYSTEM 6000 MKII
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
vss
TM
3
Early
Early Type
Several types are available - e.g. Bathroom, Car etc.
Pickthetypethatbestcomplimentsyourmaterialorbest
represents the effect you are going for.
Early Color
Range:-40/+40
Adjuststhespectralbalanceinthehighendfrequencies.
Thisisactuallyasimplewayofadjustingacomplex
selection of frequencies.
Early Pos
Here you can select between a Close and a Distant setting.
This enables you to change the distance between the
listeningpositionandthesourceinthesameEarly
Reflection pattern.
Please note that some of the Early Types only
have one position available.
Early Size
Range/Type: Small, Medium or Large
ChangesthesizeoftheEarlyTypeparameter.
Some of the Early Types are one size.
Early Lo Cut
Range: Off to 400Hz
SetstheLoCutfrequencyfortheEarlyReflections.
Early Balance
Range: -100dB R, Center, -100dB L
Theleft/rightbalanceoftheEarlyReflections.Allowsyou
tooffsettheEarlyReflectionsfromthenormalcenter
position.
Reverb
Reverb
Rev Type
Range:Smooth,Natural,Alive,Fast,FastWd,AliveWd
AdjustthisparameterwiththeEarlyLevelturnedallthe
way off and the Rev Level all the way up. Change the type
togetafeelofwhateachonesoundslike.
Rev. Width
Range: Wide, Stereo, Center or Mono
With this parameter you can change the width of the diffuse
field. The Mono setting is where the left and right Reverb
Tails are completely identical, the Center setting opens
a bit up in the middle, Stereo is the normal stereo image
width and Wide covers the outside of the stereo image.
TheRevTypes:FastWdandAliveWdonlyhave
one width (extremely wide).
Lo Cut
Range: 20Hz to 200Hz
Adjustablefilterthatallowsyoutoremovelowfrequencies
from the Reverb. The Lo Cut frequency can be perceived
as a Threshold frequency. The cut will be performed
according to the Lo Damp parameter.
Lo Damp
Range: -18dB to 0dB
Sets the amount of cut in dBs. (See Lo Cut description
above).
Hi Cut
Range:20Hzto20kHz
Rolls off the top end of the signal as it enters the Reverb.
UsedinconjunctionwithHiSoftenandHiDecayto
“darken”aroom.
Hi Soften
Range:-50to+50
HiSoftenisaspecialfilterusedto“soften”thehigh
frequencies of Reverb. This is not a simple Hi Cut filter but
acomplexsetoffiltersworkingtogethertoremovethose
frequenciesthatmakeaReverbsound“brittle”orharsh.
HiSoftenisscaled/linkedtotheHiCutandHiDecay.

Other manuals for TC Electronic SYSTEM 6000 MKII

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TC Electronic SYSTEM 6000 MKII and is the answer not in the manual?

TC Electronic SYSTEM 6000 MKII Specifications

General IconGeneral
BrandTC Electronic
ModelSYSTEM 6000 MKII
CategoryComputer Hardware
LanguageEnglish

Related product manuals