TC Electronic SYSTEM 6000 MKII Algorithm Manual

9
vss
TM
3
Rev Balance
Range: -100dB R, center, -100dB L
The left/right balance of the Reverb. Allows you to offset the
diffuse field from the normal center position.
Diffuse
Range:-50to+50
This parameter gives you more or less diffusion than the
algorithmdesignerintendedforthegivenDecaytime.For
optimumperformancethediffusionisautomaticallyadjusted
behind the scenes whenever you change Decay times.
This parameter gives you the added control to vary the
diffusion around this automatic setting.
Decay/Crossover
Lo Decay
Range:0.01to2.5
Multiplier for the frequencies below the Lo Xover frequency.
Example:IftheMainDecayparameterissetto2.0secand
theLoDecayparameterissetto1.5,frequenciesbelow
the Lo Xover will decay for 3.0 sec.
Converselyifthisparameterissetto0.5theDecaytime
below the Lo Xover point will be only 1 sec.
Lo Xover
Range:20Hzto500Hz
Sets the frequency at which the transition from the low to
thelow-midfrequenciestakesplace.
Lo Mid Decay
Range:0.01to2.5
The Ratio control multiplier for the low-mid frequencies.
Mid Xover
Range:200Hzto2kHz
Sets the frequency at which the transition from the low-mid
tothemidfrequenciestakesplace.
Hi Mid Decay
Range:0.01-2.5
The Ratio control multiplier for the mid frequencies. This
parameter is normally set to 1.0 as it is the main parameter
adjustedbythemainDecayparameter.Thismid-range
decay control would normally be omitted, however, TC
Engineersfeltyoucouldusethisparameterasafine
adjustmenttoolto“tweak”apresettosoundjustright
withouthavingtoadjustthemasterDecayparameter.
Hi Xover
Range:500Hzto20kHz
Sets the frequency at which the transition from the mid
frequenciestothehighfrequenciestakesplace.
Hi Decay
Range:0.01to2.5
Multiplier for the frequencies above the Hi Xover frequency.
Example:IfthemainDecayparameterissetto2.0secand
theHiDecayparameterissetto1.5,frequenciesabove
the Hi-Xover will decay for 3.0 sec. Conversely if this
parameterissetto0.5theDecaytimeabovetheHiXover
point will be 1 sec.
Modulation
Reverb Modulation
RevMod Type
Off, Smooth 1, Smooth 2, Perc, Wow, Vintage, Wild
Selects the type of modulation.
RevMod Rate
Range:-100,default,+100
AllowsyoutooffsetthespeedoftheLFOfromthefactory
default assigned to each Type.
RevMod Width
Range: 0% to 200%
Sets the Width of the modulation.
Space Modulation
SpcMod Type
(Off,Normal,Fast,Slow,MidFreq,Sync)
Selects the type of Space Modulation.
SpcMod Rate
Range:-100,default,+100
AllowsyoutooffsetthespeedoftheLFOfromthefactory
default assigned to each type.
SpcMod Width
Range: 0 to 100%
Sets the width of the modulation.
SpcMod Depth
Range:-50,default,+50
Allows you to offset the amount of space modulation from
the factory default.

TC Electronic SYSTEM 6000 MKII Specifications

General

Brand	TC Electronic
Model	SYSTEM 6000 MKII
Category	Computer Hardware
Language	English