Step 1: Use inner hex wrench in the accessories bag to open dome enclosure by
unfastening three inner hex screws on enclosure.
Step 2: Take out the installation position map in the accessories bag, and then paste it on
the ceiling or the wall according to your monitor area requirements.
Step 3: Find cross signs on the map, and dig three plastic expansion bolts holes on the
installation surface and then insert three expansion bolts in the holes. Secure these three
bolts firmly.
Note:
If user pulls out cable from top of installation surface, you must dig an exit hole on
installation surface according to the installation position map.
If user pulls out cable from side of cable channel, it must go through the U-shape
channel on dome pedestal, and take out cable from the side exit hole on pedestal.
Step 4: Adjust the device installation pedestal to the proper position and then pull cable
through the exit hole on Installation surface. Make direction of TOP sign same as it on
installation position map. Line up the three screw holes in the device pedestal to the three
plastic expansion bolt holes in the installation position. Put the three self-tapping screws in
the three plastic expansion bolts firmly. Fix dome body on installation surface.
Step 5:
a) Hold both sides of the rotation bracket bottom with hands, rotate the bracket horizontally,
and adjust lens horizontal direction to designated position. Loosen one M2 screw on
fixed LED decoration cover (loosen only, do not take it down), hold the decoration cover
with hand, making lens rotate vertically. Adjust vertical direction of lens monitoring
image to appropriate angle, and fasten the fix screw on the decoration cover. Range of
lens: vertical (0°～+65°), horizontal (0°～+355°).
b) Hold both sides of the rotation bracket bottom with hands, rotate horizontally along the
axis, and adjust lens horizontal direction to designated position. Hold the LED
decoration cover with hand, rotate along the vertical direction, adjust the lens vertical
direction to designated position; it is okay to loosen the fix screws on both sides of the
bracket first if it is too tight to adjust (just make it loose, do not take it down), then adjust
the lens, tighten the fix screws after adjustment. Hold the LED decoration cover with
hands, rotate horizontally along the axis, and adjust the lens image to designated
position. Range of lens: vertical (0°～ +64°), horizontal (0°～ +355°), image rotation
direction (0°～+355°).
Note:
When it rotates to 64° vertically, pay attention to the image rotation direction in order to
avoid the outer cover blocking IR light and influencing IR effect.
To Next Page
Loading...
Need help?
General
