Technica Engineering CM CAN Combo - Page 3

CM CAN Combo User Manual
3
4.4.3.2 Wake up conditions .............................................................................. 26
4.4.4 WakeUp Lines and Actuator ....................................................................... 26
4.4.5 WUP time to LOW ........................................................................................ 27
4.4.6 Sleep Timeout .............................................................................................. 28
4.4.7 Date and Time .............................................................................................. 28
4.5 Switch Status Tab ............................................................................................... 29
4.5.1 Spy multiplexer ............................................................................................ 30
4.5.1.1 EtherType .............................................................................................. 30
4.5.1.2 Enable Traffic Shaping and Traffic Bandwidth [%] ............................ 31
4.5.1.3 Destination MAC ................................................................................... 31
4.5.1.4 Enable Packetization [ms], Timeout for Packetization ...................... 31
4.5.1.5 Logging Ports for Packetization .......................................................... 31
4.5.1.6 Delay for Logging .................................................................................. 32
4.5.1.7 Filters Table ........................................................................................... 33
4.5.1.8 Edit Basic Filter ..................................................................................... 34
4.5.1.9 Edit Advance Filter ................................................................................ 36
4.5.2 Host Port ...................................................................................................... 38
4.5.3 100BASE-T1 Port ......................................................................................... 39
4.5.4 GB-A Port ...................................................................................................... 41
4.5.5 CAN Ports ..................................................................................................... 43
4.5.6 Flexray Port .................................................................................................. 45
4.5.7 RS232 Port ................................................................................................... 46
4.6 XCP Tab ............................................................................................................... 48
4.6.1 Table 1 .......................................................................................................... 49
4.6.2 Table 2 .......................................................................................................... 50
4.7 Control Message Triggers tab ........................................................................... 51
4.7.1 User Interface ............................................................................................... 51
4.7.2 Values of Control Message Entries ............................................................ 51
4.8 Synchronisation of several devices by PTP (802.1AS) ................................... 52
4.8.1 Transport of time-synchronization information ........................................ 52
4.8.2 Propagation delay measurement ............................................................... 53
4.8.3 How to setup a synchronized network with CaptureModules ................. 54
4.9 How to use Advance Filter ................................................................................. 55
4.9.1 General information ..................................................................................... 55