Technics SC-S2350 - Antenna Connections

Before use MN
RQT5333
| Connections |
Antenna connections
IP o a AM loop antenna
e Fit the AM loop antenna holder (included) onto the rear panel of this unit and then
e - j attach the AM loop antenna to the AM loop antenna holder (facing in the direction
Ho y voo | of best reception).
la
MES:
ated
'
@
Keep
loose
antenna
cord
away
from
other
wire
cords
or
a
tapedeck.
E A 0»r ooo :
e eea rmn E AR
[Es o ooo lo Ll | i
n — When mounting the antenna to a
=
kad
column,
a
wall
or
rack
Receiver
FM antenna
Fix the other end of the antenna where reception is best. |
FM
indoor
antenna
(included)
Screw
(included)
| D
Adhesive tape
(not included)
AM loop antenna
(included)
To connect an outdoor antenna
FM antenna AM loop antenna
e
Disconnect
the
FM
indoor
antenna.
e
Run
a
piece
of
vinyl
wire
horizontally
across
a
window
or
other
e The antenna should be installed by a competent technician. convenient location.
e Twist the coaxial cable's shield braid firmly and connect it to the e Leave the loop antenna connected.
GND terminal.
e Disconnect the antenna when the unit is not in use. Do not use
the antenna during an electrical storm.
FM outdoor antenna
| (not included) Vinyl-covered wire
: (not included)
75 Q coaxial cable
(not included)
20 mm (25/32*)
Shield braid
10 mm (3/8")
Core wire