Technics SC-S2350 - Aa EEE Se

|
|
|
|
|
|
|
|
|
|
!
Ll
Ik
onoomomoe:FLLaA
| _ Listening to compact discs cee
TET AT ag: Pe ee o s
Ry.
If, white listening to a certain track, you decide that you want to add
that track to your program, you can with direct programming.
Wee ee Sate:
rec [programming ;
[White the track you want to program is playing]
Press [DIRECT].
The current track will be added to the end of the program. When
you make a program as explained under “Program play”, and then
perform the above procedure without clearing the program first, the
selected track is added to the end of the program.
e You cannot add to the program if already full, that is, if 32
selections have already been programmed. If you press
[DIRECT] in this case, the message “PGM FULL” will be
displayed. Therefore, direct programming is possible only when
31 or less tracks have been programmed.
e During program play, the [DIRECT] button does not respond to
touch.
To listen to programmed tracks [El
[In the stop mode]
Press [PROGRAN] and check “PROGRAM” appears on
the display, then press [P].
The program will start from the first track.
To clear all programmed contents.
[In the stop mode]
Press [W].
You can search rapidly forward or backward on the disc for specific
sections.
[In the play or pause mode]
Press and hold [ 44] or [>> ].
“44: You can search backward.
>»: You can search forward.
Release the button when you reach the desired point.
The changer will return to the previous mode (play or pause).
In the sequential/disc grouping play mode
When the changer finishes searching the current disc, it starts
searching the next one.
In the single disc play mode
You can search forward or backward only within the current disc.
In the program play mode
You can search forward or backward only within the current track.