Technics SC-S2350 - Page 28

2
E
2
A
~
RQT5333 ~~
SOC EC EHH eee ee DERE TE DEPP a DOPE S RECORDER RA DAS seeaneresenres
(TETE ETTTETEETET]
GOO
4 5 6 2IOENTER
OOOO
7 a b
Oooo
Y
Program order
Specified track number
aonao Fran naaranarrr mor +orrrrno9 nanrerrarronaruaararorararanar nr ono ED
Listening to compact discs _
PO
i
ee
TO
Play
a
Wid
aa
baie
ED
AN
asses
Program play lets you playback your favorite tracks in the
sequence you want to hear them, The program can hold up to 32
items.
[In the stop mode]
Press [PROGRAN].
Press [CD].
This will set the remote control to operate the CD changer.
Select the disc(s) with the numbered buttons.
To select disc 3.
DISC/DECK 1/2 — 3 — DIRECT TUNING/DISC ENTER
“ALL” indicates that the whole disc is selected. To program by
disc, repeat the above. (The count increases by one for each
operation.) You can select slot No.0.
Press the numbered button(s) to specify the track.
To select track No.20.
[>10/ENTER] — [2] — [0]
To program tracks from the same disc, repeat this step.
Repeat steps 3 and 4 until you have completed all
entries.
“PGM FULL” is displayed if you attempt to enter a 33rd selection.
If you enter non-existing disc(s) or track(s), the corresponding
indicator illuminates and the entry is included in the count. During
play, the changer will cancel the non-existing entry.
Press [P ] to start play.
To enter other selections during play, repeat steps 3 and 4.
Prarvarracrraonarasa SOORFFOOF OTHE EEE E TED ET SPEER ERATE SP RESREHREEHE HEHE ETHER ESTER EAD
To clear all programmed contents
[In the stop mode]
Press [ jy}.
To quit the program mode
[In the stop mode]
Press [PROGRAM].
The changer will return to the sequential play mode.
If the mode is exited in this fashion, it is possible to re-enter the
mode and listen to the same program after enjoying other modes of
play. If discs are replaced, the new discs are included in the
program. lf a disc is removed or the new disc doesn't have the
programmed track number, those entries are canceled as the
program is played.
For your reference
The program is stored even if the unit is turned off or disconnected
from its power supply. Extended disconnection will eventually result
in erasure of the program.
III zz
Special note on recording programs
The changer needs time to change discs and find tracks.
It will take the changer slightly longer than the total track time to
record everything. How much longer depends on the program.