Technics SC-S2350 - Page 32

|
l
DECK1/2 |
DECK 1/2
O)
E
S
2
2
=i
32
A
AQTS333
Listening to cassette tapes _
~
To stop playback
Press [IN].
After listening is finished
Be sure to reduce the volume level, and switch the power to the
standby condition by pressing [POWER] of the receiver.
To change the Deck to be used E]
Press [DECK 1/2] to select the Deck you want to play.
Each time the button is pressed, the indicator will change:
DECK 1 == DECK 2
The indicator changes only if a tape is loaded in the both decks.
Reverse function
The reverse function on this unit has three modes (==, G9,
CO ). Read the descriptions below and select the mode as
desired.
Tape travel
Only one side of the tape (either the forward side or
the reverse side) will be played, and operation will
automatically stop when playback has been
completed.
Both sides of the tape will be played repeatedly eight
times, and then operation will automatically stop.
(If playback is begun from the reverse side, the
forward side will be played seven times.)
When there is a tape in only one of the decks
Both sides of the tape will be played once, and then
operation will automatically stop.
(If playback is begun from the reverse side, the
forward side will not be played.)
When there is a tape in each of the decks
The forward and reverse sides of the tape in Deck 1
will be played, followed by the forward and reverse
sides of the tape in Deck 2, and after this operation
is repeated eight times, operation will automatically
stop.
(If playback is begun from Deck 2, the tape in Deck
1 will be played seven times.)
Dolby noise-reduction system
The Dolby noise-reduction system is designed to effectively reduce
the annoying high-frequency “hissing” noise which typical of
cassette tapes. During recording, the system functions to increase
the high-frequency sound level, and then, during playback, that
same portion is weakened to bring it back to the previous level.
This unit is equipped with the Dolby B NR-type.
Dolby B-type noise-reduction
Noise is reduced to about one-third.
Use this system when playing back tapes recorded by the Dolby-B
noise-reduction system, such as prerecorded music tapes, etc.
Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol DO are trademarks of
Dolby Laboratories Licensing Corporation.