RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 8.5
8.4. LIMIT SWITCH POSITION
Figure 8.4-1
Carry out the procedure described in
paragraph: 7.12. Motor guard disassembly”.
1. Loosen the 2 screws (a) fixing the limit
switch to the casing.
Figure 8.4-2
2. Adjust the position of the limit switch so that
it touches the guard without to be pressed.
Take care the limit switch lever is not
pressed on the guard.
3. After making the adjustment, lock down the
screws (a) backed off previously.
To Next Page