RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 9.27
9.4.1.3. Default Setting
To load the default parameter values, scroll using the +/- effort level keys until the display shows:
DEFAULT SETTING ?
press ENTER to write the default values to the low kit, and return to the upper menu level by
pressing CLEAR for a few seconds.
To write these parameters to the low kit, use the “Write to low kit” function.
9.4.1.4.
Table of configuration parameters
Display
parameter
Description Range Default values
Par 01 Default linear speed n.m. 8
Par 02 Default acceleration and deceleration n.m. 100
Par 03 default slope setpoint n.m. 0
Par 04 PID proportional gain n.m. 7
Par 05 PID Integral gain n.m. 150
Par 06 S Ramp Type n.m. 0
Par 07 Flag DC motor encoder signal alarm action 0 - 1 0
Par 08 Watchdog serial communication n.m. 0
Par 09 DC motor encoder error timeout 1 cnt = 100 msec 0 - 255 15
Par 10
Flag signal receiving Sw Emergency and not
receiving Emergency Hw
- 0
Par 11 roll diameter n.m. 91
Par 12 roller diameter n.m. 200
Par 13 Flag posting warning signal AC motor encoder 0 - 1 0
n.m = Value not modifiable.
To Next Page