RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 12.1
12. APPENDICE
12.1. UPDATING THE SW
To upgrade the SW of the machine you must change the contents of Display/CPU board FLASH
EPROM, using an external PC and the SW “Service Excite Loader”, which will connect to the
CSafe board of the machine, located at the rear of the panel.
The PC can only update the FLASH EPROM during machine power up, before the self-
test sequence begins.
After the Display SW update it is necessary to restore all the parameters to the default
values following the detailed instructions provided in paragraph 9.2.14. “Resetting
parameters to default values”.
After the lower electronic SW update it is necessary to restore all the parameters to the
default values following the detailed instructions provided in paragraph 9.4.2.3 “Default
setting”.
To Next Page