RUN EXCITE-2008: Service & Maintenance Manual - rev. 1.3
Page 6.21
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
(1) Check that the antenna cable is correctly connected to the TUNER on Digital TV board.
(2) Carry out the the configuration procedure as detailed at paragraph: 5.2. “Specifications and
requirements to install a Wellness TV machine”
(3) Check that the antenna signal matches with the minimal requested specifications detailed at
paragraph: 5.2. “Specifications and requirements to install a Wellness TV machine”.
If you replace Display board/Brake board, check that its SW version is updated,
otherwise install the last version.
The TV channels table has to be both on the Digital TV and CPU board. This means
that in case even also only one of the 2 boards is being replaced, it is necessary to search
or transfer from another machine and memorise again the TV channels list.
To Next Page
Loading...
