Tekelec EAGLE 5 - Page 126

Request syntax:
dlt_eir([iid XXXXX] imei XXXXX)
Delete a Block of IMEIs
The dlt_eir command defines the request message to delete an IMEI block.
Parameters :
The beginning IMEI in a block.
bimei
14 or 15 hexadecimal digits expressed using ASCII characters. Only
the first 14 digits of the IMEI are stored and displayed on retrieval.
Values:
The ending IMEI in a block.
eimei
14 or 15 hexadecimal digits expressed using ASCII characters. Only
the first 14 digits of the IMEI are stored and displayed on retrieval.
Values:
(Optional) Specify the number of seconds to wait for the write transaction if another
connection already has it. Clients waiting for the write transaction with this mechanism
timeout
are processed in the order that their requests were received. This option is only allowed
if the client used the txnmode single option on its connect request.
0 (return immediately if not available; default)
Values:
1 - 3600 seconds
Rules
1. If the imei includes the optional 15th character (the check digit), the check digit is provided by the
Customers Client Software and must match the EPAPs (via calculated algorithm). The check digit
is not stored; it is only used to verify the imei.
Request syntax:
dlt_eir([iid XXXXX,] bimei XXXXX, eimei XXXXX)
Delete IMSI(s) from the Associated IMEI
This command is used to delete the IMSI from the specified IMEI. This is the EIR specific IMSI, not
the G-Port/G-Flex IMSI.
The dlt_eir command is used to delete the IMSI from the associated IMEI.
Parameters :
A single IMEI.
imei
126
910-6022-001 Revision A, March 2011
PDBI Request/Response MessagesProvisioning Database Interface Manual