Operating basics
Menu readout up
dates. Many of the menu readouts are static and do not update
when instrument conditions change. To view the latest menu readout information,
press the BACK button to exit the current menu and then press the ENTER button
to reenter the menu and view the current readout information. This is especially
useful when viewing items in the STATUS menu.
Web User Interface
The ECO8000 Series has a 10/100 BASE-T Ethernet port on the rear panel that
allows you to use a PC to remotely control the instrument. When the Web
Interface is enabled in the SYSTEM CONFIG menu, enter the IP address of the
instrument in a supported Web browser to open the ECO8000 Web Interface.
Easy access and control. The Web-based interface allow s quick access to most
of the instrument settings and views. In most cases, it is easier to access and
configure the instrument using the Web Interface. Examples of where this is
especially true are:
Viewing instrument status
Viewing the Event Log
Viewing diagnostic results
Config
uring event and email reporting
Configuring channel settings such as threshold levels, labels, etc.
Operating limitations. All of the settings and functions that can configured using
the front panel are available in the Web Interface except for the following:
Configuring the SNMP settings
Co
nfiguring the network settings
Configuring the Web Interface level of control setting
Performing a firmware upgrade
1–4 ECO8000 Series Service Manual
To Next Page
Loading...
Need help?
General
