List of Figures
Figure 1-1: Location of rear panel power connectors (ECO8000 shown) ................................. 1-2
Figure 2-1: ECO8000 Series subsystems (ECO8020 with Option DPW shown) ......................... 2-1
Figure 2-2: ECO8000 Series high-level block diagram...................................................... 2-3
Figure 3-1:
Installing or removing the instrument into or from the rack .. ................................ . 3-7
Figure 3-2: Removing the top cover ........................................................................... 3-8
Figure 3-3: Board locator and cable routing diagram ...................................................... 3-10
Figure 3-4: Removing the cable tie........................................................................... 3-11
Figure 3-5: Removing the multi-wire channel cables ........................... .................. ......... 3-11
Figure 3-6: Removing the circuit board support bracket................................................... 3-12
Figure 3
-7: Removing the BNC nuts from a channel module ............................................. 3-13
Figure 3-8: Removing a channel module .................................................................... 3-13
Figure 3-9: Installing channel cable example: Slot 1 on the Main board to the channel 1 module ... 3-14
Figure 3-10: Disconnecting the Main board power cable from the Combiner board ................... 3-16
Figure 3-11: Threading the power cables through the circuit board support bracket ................... 3-17
Figure 3-12: Positioning the support bracket tabs with the circuit boards ............ .................. . 3-18
Figu
re 3-13: Installing the channel 1 board cable (Slot 1 to channel 1 board) .......................... 3-19
Figure 3-14: Disconnecting the line filter power cables from the Combiner board..................... 3-20
Figure 3-15: Light pipe connections ......................................................................... 3-21
Figure 4-1: Component locations on the Combiner board................................................. 4-17
Figure 4-2: Component locations on the Processor and Main boards .................................... 4-18
Figure 5-1: Front panel assembly and Power Supply module............................................... 5-3
Fi
gure 5-2: Main chassis and ECO8000 rear panel........................................................... 5-5
Figure 5-3: ECO8020 rear panel................................................................................ 5-8
ECO8000 Series Service Manual iii
To Next Page
Loading...
Need help?
General
