96
Phaser 740 and 750 Color Printers
Cartridge selector/eject unit (right door)
1.
Disconnect the cartridge selector/eject unit’s wiring harness.
2.
Counting from the rear of the shaft, remove the third E-ring from the
cartridge selector/eject unit’s shaft.
3.
Remove the E-ring and keyed bushings from each end of the cartridge
selector/eject unit’s shaft.
4.
Remove the E-ring second from the front of the cartridge selector/eject
unit’s shaft.
Caution
In the next step, do not bend the frame to give additional clearance, as a
damaged frame is not replaceable.
5.
Unlatch the cartridge selector/eject unit and lower it half-way down to
relieve spring pressure to enable moving the cartridge selector/eject unit’s
shaft. Slide the shaft forward until it clears the frame. If necessary, tap the
rear end of the shaft with a screwdriver handle (no metal) to move it
forward.
6.
Unhook the tension springs at each end of the shaft from the engine frame.
Note how they fasten to the frame and the right door.
7.
Beginning at the rear, remove the cartridge selector/eject unit.
To Next Page
Loading...
General