EasyManuals Logo

Tektronix Phaser 740 User Manual

Tektronix Phaser 740
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Users safety summary
Terms in
CAUTION Conditions that can result in damage to the product.
manual:
WARNING Conditions that can result in personal injury
or loss of life.
Power source:
For 110 VAC printers, Do not apply more than 130 volts RMS between
the supply conductors or between either supply conductor and ground. Use only the
specified power cord and connector. For 220 VAC printers, Do not apply more than
250 volts RMS between the supply conductors or between either supply conductor
and ground. Use only the specified power cord and connector.Refer to a qualified
service technician for changes to the cord or connector.
Operation of product:
Avoid electric shock by contacting a qualified service technician
to replace fuses inside the product. Do not operate without the covers and panels
properly installed. Do not operate in an atmosphere of explosive gases.
WARNING Turning the power off using the On/Off switch does
not de-energize the printer. You must remove the power cord to
disconnect the printer from the mains. Keep the power cord
accessible for removal in case of an emergency.
Safety instructions:
Read all installation instructions carefully before you plug the
product into a power source.
Terms on
CAUTION A personal injury hazard exists that may not be
product:
apparent. For example, a panel may cover the hazardous area.
Also applies to a hazard to property including the product itself.
DANGER A personal injury hazard exists in the area where
you see the sign.
Care of product:
Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise damaged,
if you spill anything into the case, if product is exposed to any excess moisture, if
product is dropped or damaged, if you suspect that the product needs servicing or
repair, and whenever you clean the product.
Ground the product:
Plug the three-wire power cord (with grounding prong) into
grounded AC outlets only. If necessary, contact a licensed electrician to install a
properly grounded outlet.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix Phaser 740 and is the answer not in the manual?

Tektronix Phaser 740 Specifications

General IconGeneral
BrandTektronix
ModelPhaser 740
CategoryPrinter
LanguageEnglish