Service Guide
39
Verifying printer operation by using its self-test print
1.
If not already on, turn on the printer. If the printer does not power up, or does
not initialize, or the printer initializes but the motors do not run properly, go to
the next topic “Verifying power supply operation.”
2.
When the
Ready
message is displayed, press the
Menu
button to enter the menu.
3.
Press the scroll buttons to navigate to the Test Prints menu item. Select any test
print.
4.
Press
Print
to print a test prints. The printer should print a test page from the
image processor memory.
If the printer prints a test pattern, then the print engine and image processor are
working correctly and the printer's problem resides with the network or host
interface.
Verifying power supply operation
Verifying the power supply involves four steps:
■
Measuring the input and output voltages.
■
Checking the power supply fuse(s).
■
Checking its safety interlocks.
■
Testing for a shorted motor which would shut down the power supply or
damage the engine control board.
Measuring power supply voltages
1.
Turn off the printer and unplug it from its power outlet.
2.
AC Input:
With the VOM set to measure AC voltages, measure for power being
supplied to the printer. It should measure between 87 to 128 VAC (115 VAC
nominal) or 174 to 250 VAC (220 VAC nominal).
3.
Power supply fan
: With the power switch on, is the main fan running? If not,
check the fan’s wiring harness (CN9) to the engine control board; it should
measure 24 VDC. If the voltage is not correct, replace the engine control board.
Otherwise, replace the power supply fan.
Required tools
■
#1 Phillips
screwdriver
■
Volt-ohm-meter (VOM)
To Next Page
Loading...
General