Tektronix TPS2000 Series User Manual

Specifications
TPS2000 Series Digital Storage Oscilloscopes S ervice Manual
1-3
Table 1- 1: Oscilloscope general characteristics (Cont.)
Vertical
Digitizers 8-bit resolution (except when set to 2 mV/div), each channel sampled simultaneously.
VOLTS/DIV Range 2 mV/div t o 5 V/div at input BNC
Position Range 2 mV/div t o 200 mV/div, 2V
>200 mV/div to 5 V/div, 50 V
n Analog Bandwidth in
TPS2012 and TPS2014 TPS2024
n
A
n
a
l
o
g
B
a
n
d
w
i
d
t
h
i
n
Sample and Average modes
at BNC or with P2220 probe
set to 10X, DC Coupl ed
100 MHz
1
200 MHz
1(
5 mV/div bandwidth is 200 MHz, typical)
10 mV/div bandwi dth is 200 MH z from 0 °Cto40°C ambient.
Deratedto160MHzat50°C.
20 MHz when vertical scale is set to less than 5 mV.
Analog Bandwidth i n Peak
D
e
t
e
c
t
m
o
d
e
(
5
0
s
/
d
i
v
t
o
75 MHz
1
D
ete
c
tmo
d
e
(
50 s
/
d
i
v
to
5 s/div
2
), typical
20 MHz when vertical scale is set to less than 5 mV
Selectable Analog Bandwidth
Limit, typical
20 MHz
Lower Frequency Limit,
AC Coupled
≤10 Hz at BNC
≤1 Hz when using a 10X passive probe
Rise Time at BNC, typical TPS 2012 and TPS2014 TPS2024
,
y
p
<3.5ns <2.1ns
Peak Detect Response
2
Captures 50% or greater am plitude of pulses ≥12 ns wide typical (50 s/div to 5 s/div) in the
center 8 vert ical di v isions
n DC Gain Accuracy
±3% for Sample or Average acquisition mode, 5 V/di v to 10 mV/div
n
D
C
G
a
i
n
A
c
c
u
r
a
c
y
±4% for Sample or Average acquisition mode, 5 mV/div and 2 mV/div
n DC Measurement
Measurement Type Accuracy
n
D
C
M
e
a
s
u
r
e
m
e
n
t
Accuracy, Average Acquisition
Mode
Average of ≥16 wave-
forms with vertical posi-
tion at zero
±(3% × reading + 0.1 div + 1 mV) when 10 mV/div or greater is
selected
Average of ≥16 wave-
forms with vertical posi-
tion not at zero
±[3% × (reading + vertical position) + 1% of vertical position +
0.2 div]
Add 2 mV for set tings from 2 mV/div to 200 mV/div
Add 50 mV for settings f rom >200 mV/div to 5 V/div
Volts Measurement Repeat -
ability, Average Acquisition
Mode
Delta volts between any
two averages of ≥16
waveforms acquired
under same setup and
ambient conditions
±(3% × reading + 0.05 div)
1
When vertical scal e is set to ≥ 5mV.
2
The oscilloscope reverts to Sample mode when the SEC/DIV (horizontal scale) is set from 2.5 s/div to 5 ns/div
on 100 MHz model s, or from 2.5 s/div to 2.5 ns/di v on a TPS2024 model. The Sample mode can still capture 12
ns glitches.

Tektronix TPS2000 Series Specifications

General

Brand	Tektronix
Model	TPS2000 Series
Category	Test Equipment
Language	English