27
Installation
Connect ADHB-4 Hardware
To make hardware connections to the ADHB-4, do the following:
1. Connect the 10/100 Network cable to the IP Network and the ADHB-4.
2. Connect a speaker pair to the SPEAKER 1–2 jack.
3. Connect an RJ-11 desk mic to the DESKMIC jack.
OR
Connect an XLR desk mic to the XLR jack on the side panel.
OR
Connect, matching polarity hash marks with headset connector grooves, a dual 1/4” headset connector to the
HEADSET jack, to the connector on the side panel.
4. Connect optional audio devices:
• NENA to the NENA jack.
• Footswitch to the FOOTSWITCH jack.
• Recorder/accessory to the ACCESSORY port.
• Speaker pair(s) to the SPEAKER 3–4, or 5–6 jack.
• Install RHB(s) to the REMOTE HEADSET 1 and/or 2 ports.
NOTE: For more information, see “RHB Installation” on page 75.
5. Ensure power is supplied to the speaker pair(s).
6. Ensure the speaker volume and headset volume are turned to an audible level.
IMPORTANT:
• Do not connect the ADHB-4 to power until after C-Soft installation.
• Do not connect the USB cable to the PC until after C-Soft Installation.
C-Soft Installation
The C-Soft installation is described in the C-Soft Software Console Administrator’s Guide (P/N LIT000082000) available on
the CD that ships with the ADHB-4 or can be downloaded at www.Telex.com/Downloads/.
IMPORTANT: Before C-Soft installation, ensure the USB is not connected to the ADHB-4.
ADHB-4 Driver Installation
The ADHB-4 Driver installation process begins after a USB connection to the PC is established. Since the installation
requires access to the usb_drivers folder, which is included in the C-Soft installation folder, C-Soft must be installed before the
ADHB-4 driver.
• PCs running Windows XP install C-Soft and the ADHB-4 driver separately. See “Install the ADHB-4 Driver
with Windows 7” on page 28.
• PCs running Windows 7 install the ADHB-4 driver right after C-Soft is installed. See “Install the ADHB-4
Driver with Windows 7” on page 28.
To Next Page
Loading...