Telex ADHB-4 - Ethernet Setup Window; Use Dhcp Check Box

39
Configuration
Ethernet Setup Window
The Ethernet Setup window, shown in Figure 24, is used to configure the ADHB-4’s network parameters. See your network
administer to determine Ethernet Address field values.
BASE IP SETUP
Use DHCP Check Box
The Use DHCP check box is used to enable the ADHB-4 to automatically obtain the Unit IP Address from the network. Once
selected, all other fields on the window are disabled from use.
The default for this field is, disabled.
NOTE:
• The network must support DHCP if DHCP is used.
• Bosch does not recommend enabling DHCP.
FIGURE 24. Ethernet Setup Window