50
System Setup Window
NENA/PHONE MIC SOURCE SETUP
The NENA/PHONE MIC SOURCE SETUP section is used to configure microphone source priorities when a
NENA/phone is active on the ADHB-4. Up to three (3) different microphone sources can be set up when a
NENA/phone is connected and onhook. Once the NENA/phone is taken offhook (low), the ADHB-4 transmits full-duplex
audio to the NENA/phone.
NOTE: A NENA/phone cannot operate without headsets selected that are configured for use at the console position.
The default for these fields is:
Headset Mic #1
RHB 1 #2
RHB 2 #3
EXAMPLE: When the defaults are sets the audio is routed as follows:
If a headset, an RHB 1, and an RHB 2 connected, and the NENA/Phone is taken offhook, audio is routed to
the headset’s earpiece.
If an RHB 1 and an RHB 2 are connected, and the NENA/phone is taken offhook, audio is routed to the
RHB 1.
If an RHB 2 is connected, and the NENA/phone is taken offhook, audio is routed to the RHB 2.
Headset Mic #1–#4 Radio Buttons
The Headset Mic #1–#4 radio buttons indicate the priority for routing audio through the headset when the headset generates a
PTT while the NENA is offhook.
Headset Mic Disable Radio Button
The Headset Mic Disable radio button indicates the headset is disabled from routing audio when the NENA is offhook.
RHB 1 Mic #1–#4 Radio Buttons
The RHB 1 Mic #1–#4 radio buttons indicate the priority for routing audio through RHB 1 when RHB 1’s headset generates a
PTT while the NENA is offhook.
RHB 1 Mic Disable Radio Button
The RHB 1 Mic Disable radio button indicates the RHB 1 is disabled from routing audio when the NENA is offhook.
RHB 2 Mic #1–#4 Radio Buttons
The RHB 2 Mic #1–#4 radio buttons indicate the priority for routing audio through the RHB 2 when RHB 2’s headset
generates a PTT while the NENA is offhook.
RHB 2 Mic Disable Radio Button
The RHB 2 Mic Disable radio button indicates the RHB 2 is disabled from routing audio when the NENA is offhook.
To Next Page
Loading...