To Next Page

To Previous Page

LE910Cx Hardware Design Guide

1VV0301298 Rev.40 Page 144 of 149 2023-03-16

Not Subject to NDA

Revision Date Changes

Section 10-3 - Recommended Footprint for the Application updated

for LE910Cx-WWX

Table 20: LE910Cx Current Consumption updated

Section 10.x – Dimension and Mechanical design updated

32 2021-03-23 Section 5.3.3 – Fixed Typo in Note of Section.

Section 8.6 – Update PCM CLK rate.

31 2021-02-05 Table 1: Applicability Table updated

Table4: RF Bands per Regional Variant updated

2.8.1 Dimensions updated

3.1 Note added

30 2021-01-29 Section 2.3 – Added not supported function only based on TreadX OS models

Section 8.5.1 – Updated Note

29 2021-01-12 Updated Section 8.6 – updated I2S diagram

28 2020-12-08 Updated APPLICABILITY TABLE and added notes

Section 3.1 – Updated Pin-out

Section 5.2 – Updated Initialization and Activation figure and added timing table

Section 5.3 – Updated figures

Section 14.1 - Updated FCC/ISED Regulatory Notices

Updated Table 60: RF Bands per Regional Variant

27 2020-07-31 Section 11.4 – Updated EMC Recommendations

26 2020-07-22 7.4 Antenna Diversity Requirements – Note comment changed to AT#RXDIV

14.4 ANATEL Regulatory Notices - Updated

25 2020-06-15 Section 8 – Hardware Interfaces; USB part updated

Section 8.1 – Note Updated

Table 45 and 4 - EUX variant added

Table 46 – CAT 4 DL/UL Tput swapped

Section 14.1 ANATEL Regulatory Notices – Homologation No. fixed

Section 2.7.1 Sensitivity – Sensitivity Table added

Section 2.2. Applications – E-call comment deleted

Table 47 – Sensitivity level changed

Sections 7.4 Antenna Diversity Requirements – Note comment changed

Section 7.5 GNSS Antenna Requirements – Note added

Table 39 – Sensitivity table changed and note added

24 2020-04-29 Section 8.3 – SGMII interface updated

Telit Wireless Solutions LE910C1-AP Hardware Design Guide

Other manuals for Telit Wireless Solutions LE910C1-AP