EasyManuals Logo

Telit Wireless Solutions ME910G1 Design Guide

Telit Wireless Solutions ME910G1
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
ME910G1 Hardware Design Guide
1VV0301593 Rev.12 Page 79 of 93 2021-09-24
Not Subject to NDA
FCC and ISED Regulatory Notices/
Avis Réglementaires de FCC et
ISDE
Modification statement /
Déclaration de modification
Telit has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user’s authority to operate the equipment.
Telit n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en
soit la nature. Tout changement ou modification peuvent annuler le droit d’utilisation de
l’appareil par l’utilisateur.
Interference statement /
Déclaration d'interférence
This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Wireless notice /
Wireless avis
This device complies with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines
and RSS102 of the ISED radio frequency (RF) Exposure rules. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter. The
antenna should be installed and operated with minimum distance of 20 cm between the
radiator and your body.
Le présent appareil est conforme à l'exposition aux radiations FCC / ISED définies pour
un environnement non contrôlé et répond aux directives d'exposition de la fréquence de
la FCC radiofréquence (RF) et RSS
102 de la fréquence radio (RF) ISED règles
d'exposition. L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à
autre antenne ou autre émetteur. L'antenne doit être installée de façon à garder une
distance minimale de 20 centimètres entre la source de rayonnements et votre corps.
FCC Class B digital device notice (FCC only)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

Table of Contents

Other manuals for Telit Wireless Solutions ME910G1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions ME910G1 and is the answer not in the manual?

Telit Wireless Solutions ME910G1 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelME910G1
CategoryWireless modules
LanguageEnglish

Related product manuals