V1.1-OCTOBER 2019
| 25
OMNIA MPX NODE MANUAL
Save
After changing any of the System Settings in this section, use the Save button to confirm
your changes. If you leave the System Setup page before pressing Save, changes will be
discarded. A “General Settings updated” message will appear in the upper right corner of
the display whenever you save changes.
Reboot
The Reboot control restarts your MPX Node, without switching software banks. A
confirmation screen (below) will ask you to confirm or cancel. Rebooting takes around
40 seconds, so make sure you unit is not on air when using it. If you have made changes
to IP address settings and are rebooting the system from remote, be sure you have new
addresses written down so you can still access the unit once rebooting is complete.
To Next Page
Loading...