Need help?Do you have a question about the Telos Alliance Omnia MPX Node and is the answer not in the manual?
General| Network Connectivity | Ethernet |
|---|---|
| Power Supply | 100-240 VAC, 50/60 Hz |
| Composite Output | Yes |
| Bit Depth | 24-bit |
| THD+N | <0.01% |
| Dimensions | 1RU |
| Form Factor | Rackmount |
| Input Connectors | XLR |
| Output Connectors | BNC |
| Sample Rate | 48 kHz |
| Frequency Response | 20 Hz - 15 kHz |
| Signal-to-Noise Ratio | >90 dB |
| Weight | Approx. 2.5 kg |
| Input Types | AES/EBU, Analog |
Technical details on the µMPX audio codec for FM signals.
Step-by-step guide to obtain an IP address for the MPX Node.
Instructions on how to log into the MPX Node via its web interface.
Configuration for dual encoders feeding a single decoder for redundancy.
Configuration for dual encoders and dual decoders for enhanced redundancy.
Setup for IP, gateway, mask, mode, and DNS settings.
Core µMPX encoder settings including input level and bitrate.
Settings for error correction, rate limiting, and keyframes.
Core µMPX decoder settings including output level and stream receiver.
To Next Page