V1.1-OCTOBER 2019
| 43
OMNIA MPX NODE MANUAL
Decoder GPO Pulse Functions Decoder GPI Pulse Functions
Receiving Stream Start µMPX Decoder
Not Receiving Stream Stop µMPX Decoder
Playing Stream Restart µMPX Decoder
Not Playing Stream Main Port Active
Network1 up Alternate Port Active
Network1 down Play test tone
Network2 up Stop test tone
Network2 down Reboot MPX Node
Note that default Pulse pin polarity is wired low to high. For a pin diagram, refer to the
Rear Panel chapter.
To Next Page
Loading...