Maintenance Inspection Report – Scissor Lifts
24 Scissor Lifts Maintenance Manual Part No. 1305686GT
Hour meter Date
Serial number Inspector company Machine owner
Inspection Type
Q = quarterly or frequent inspections
A = annual inspections
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
∅ = not applicable
Make copies of this report to use for each inspection.
Select the appropriate procedures for the type of
inspection(s) to perform.
If any inspection receives an "N," tag and remove the machine from service, repair and re-inspect it. After repair, place a "R" in the box.
Intervals
Q A
Inspect the Electrical Contactors – GS-30m,
GS-30, GS-32m, GS-32, GS-46, GS-55,
GS-69 DC, GS-69 BE
Q-6
Inspect the Fuel Tank Check Valve Venting
System - GS-69 RT Gas Models
Q-12
Inspect the Tires, Wheels and Lug Nut Torque Q-15
Confirm the Proper Brake Configuration - GS-69,
GS-84, GS-90
Q-16
Check the Drive Hub Oil Level and Fastener
Torque
A-1
∅
Test the Oscillate Axle - GS-90 A-3
∅
Check the Steer Yoke King Pin Fastener Torque -
GS-84, GS-90
A-8
∅
Chassis Mechanicals and Hydraulics
Intervals
Q A
Check the Module Tray Latch Components Q-3
Visual Inspection of the Hydraulic Oil Q-9
Inspect the Hydraulic Filters Q-10
Test the Function Pump - GS-69 BE, GS-69 DC A-2
∅
Intervals
Q A
Battery Inspection Q-2
Inspect the Battery Balancer - GS-69 DC Q-4
Inspect the Electrical Wiring Q-5
Inspect the Voltage Inverter (if equipped) Q-7
Intervals
Q A
Check the Exhaust System – Engine Models Q-11
Check and Adjust the Engine RPM Q-14
Intervals
Q A
Test the Platform Overload Pressure Transducer
and Platform Height Sensor
A-5
∅
Test the Platform Overload System – GS-30m,
GS-30, GS-32m, GS-32, GS-46, GS-55
A-6
∅
Test the Platform Overload System -
GS-69, GS-84, GS-90
A-7
∅
Intervals
Q A
Check for Open Bulletins and Owner Registration Q-1
Test the Flashing Beacons (if equipped) Q-8
Test the Fuel Select Operation - Gasoline/LPG
Models
Q-13
Test the Drive Brakes Q-17
Test the Drive Speed – Stowed Position Q-18
Test the Drive Speed - Raised Position Q-19
Test the Down Limit Switch, Level Sensor and
Pothole Limit Switches - GS-30, GS-32, GS-46,
GS-55
Q-20
Test the Descent Delay - GS-69, GS-84, GS-90
(if equipped)
A-4
∅