November 2021 Maintenance Manual
Programmed Maintenance Procedures
Part No. 1305686GT Scissor Lifts 87
P3-1
Perform Engine Maintenance –
3000 Hours
Engine specifications require that this procedure
be performed every 3000 hours.
Required maintenance procedures and additional
engine information are available in the
manufacturer's manuals. Refer to Specifications,
Engine Operator and Maintenance Manuals.
Deutz Models
D2011L03i
• Charge air cooler entry- drain lube
oil/condensate
• Injection valve- replace
D 2.9 L4, TD 2.2 L3
• Cooling system coolant - replace
• V-rib belt and tensioning pulley - replace
Ford Models
• Coolant filler cap - clean/replace
Perkins Models
• Water pump - inspect
• Fuel Injector - test/change
• Cooling system coolant (Heavy Duty) -
change
Kubota Models
• Injection pump - check
• Fuel injection timing - check
To Next Page
Loading...
Need help?
General
