November 2021 Maintenance Manual
Programmed Maintenance Procedures
Part No. 1305686GT Scissor Lifts 69
P0-2
Grease the Steer Yokes -
GS-30m, GS-30, GS-32, GS-46,
GS-55
Genie specifications require that this procedure be
performed every 100 hours of operation.
Regular application of lubrication to the steer
yokes is essential to good machine performance
and service life. Continued use of an insufficiently
greased steer yoke will result in component
damage.
1 Locate the grease fitting on the top of the
steer yoke.
2 Pump multipurpose grease into the steer yoke
until the steer yoke is full and grease is being
forced past the bearings. Repeat this step for
the other steer yoke.
-duty grease, EP NLGI 2 (lithium based)
P0-3
Replace the Drive Hub Oil -
GS-30, GS-32m, GS-32, GS-46,
GS-55
Drive hub specifications require that this procedure
be performed after the first 50 hours of operation.
After the initial oil replacement, specifications
require that this procedure be performed every
200 hours.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil at yearly intervals may
cause the machine to perform poorly and
continued use may result in component damage
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove the plugs and drain the oil into a
suitable container.
3 Drive the machine until one of the two plugs is
at the highest point.
1 drive hub plugs
4 Fill the hub until the oil level is even with the
bottom of the lowest plug hole. Refer to
Specifications, Machine Specifications.
5 Install the plugs into the drive hub.
6 Repeat this procedure for each drive hub.
To Next Page
Loading...
Need help?
General
