Maintenance Manual November 2021
Quarterly Maintenance Procedures
36 Scissor Lifts Part No. 1305686GT
Q-8
Test the Flashing Beacons (if
equipped)
Genie specifications require that this procedure be
performed quarterly.
Flashing beacons are used to alert operators and
ground personnel of machine proximity and
motion. The flashing beacons are located on both
sides of the machine.
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both ground and platform controls.
Result: The beacons should flash.
2 Turn the key switch to platform controls.
Result: The beacons should flash.
Q-9
Visual Inspection of the Hydraulic
Oil
Genie specifications require that this procedure be
performed quarterly.
Replacement or testing of the hydraulic oil is
essential for good machine performance and
service life. Dirty oil and a clogged suction strainer
may cause the machine to perform poorly and
continued use may cause component damage.
Extremely dirty conditions may require oil changes
to be performed more often. For hydraulic oil
specifications, Refer to Specifications, Hydraulic
Specifications.
Note: Before replacing the hydraulic oil, the oil
may be tested by an oil distributor for specific
levels of contamination to verify that changing the
oil is necessary. Replace the oil when it fails the
test. Refer to Maintenance Procedure, Test or
Replace the Hydraulic Oil.
To Next Page
Loading...
Need help?
General
