Terex Genie GS-1330m Maintenance Manual

Programmed
November 2021
Maintenance Inspection Report – Scissor Lifts
Part No. 1305686GT Scissor Lifts Maintenance Manual 25
Model
Hour meter Date
Serial number Inspector company Machine owner
Inspected by (print)
Inspector signature
Programmed maintenance will be completed based on machine
hours. This program includes the onetime or commissioning
procedures for new products.
The onetime procedures will be completed at 50 or 150 hours.
Legend
Y = yes, acceptable
N = no, remove from
service
R = repaired
∅ = not applicable
Make copies of this report to use for each
inspection.
Select the appropriate procedures for the type
of inspection(s) to perform.
If any inspection receives an "N," tag and remove the machine from service, repair and re-inspect it. After repair, place a "R" in the box.
Commissioning
50 150
50 Hour Service - all models C-1
∅
Perform Engine Maintenance - 50 Hours C-2
∅
Perform 150 Hour Service C-3
∅
Programmed Maintenance - Under 1000 HRS
Status Enter
Hours
Inspect the Engine Air Filter - GS-69 RT P0-1 40
Grease the Steer Yokes – GS-30m, GS-30,
GS-32, GS-46, GS-55
P0-2 100
Replace the Drive Hub Oil – GS-30, GS-32m,
GS-32, GS-46, GS-55
P0-3 200
Engines - Deutz Under 1000 Hours P0-4
Engines - Ford Under 1000 Hours P0-5
Engines - Kohler Under 1000 Hours P0-6
Engines - Kubota Under 1000 Hours P0-7
Engines - Perkins Under 1000 Hours P0-8
Engines - GM Under 1000 Hours P0-9
Programmed Maintenance
Hours are in thousands
All models Perform every: 1 2 3 4 5 6
Engines - all models, 1000 Hours P1-1
∅ ∅ ∅ ∅ ∅
Replace the Drive Hub Oil - GS-69,
GS-84, GS-90
P1-2
∅ ∅ ∅ ∅ ∅
Engines - all models, 2000 Hours P2-1
∅ ∅ ∅ ∅ ∅
Replace the Hydraulic Filters P2-2
∅ ∅ ∅ ∅ ∅
Check the Free-wheel Configuration -
GS-84, GS-90
P2-3
∅ ∅ ∅ ∅ ∅
Check the Scissor Arm Wear Pads
(and Slider Blocks, If Equipped)
P2-4
∅ ∅ ∅ ∅ ∅
Grease the Steer Axle Wheel
Bearings - GS-69 BE, GS-69 DC
P2-5
∅ ∅ ∅ ∅ ∅
Test or Replace the Hydraulic Oil P2-6
∅ ∅ ∅ ∅ ∅
Engines - all models, 3000 Hours P3-1
∅ ∅ ∅ ∅ ∅
Engines – Deutz D 2.9 L4, TD 2.2 L3,
5000 Hours
P5-1
∅ ∅
∅
∅ ∅
Engines – Deutz D2011L03i, 6000
Hours
P6-1
∅ ∅
∅
∅ ∅

Terex Genie GS-1330m Specifications

General

Brand	Terex
Model	Genie GS-1330m
Category	Lifting Systems
Language	English