Maintenance Manual November 2021
Quarterly Maintenance Procedures
50 Scissor Lifts Part No. 1305686GT
31 Repeat this procedure beginning with step
30 for the left pothole guard.
32 Lower the platform to the stowed position,
remove the block under the left pothole guard.
33 GS-55: Raise the platform approximately
13 feet / 4 m.
All other models: Raise the platform 7 to
8 feet / 2,1 to 2,4 m.
34 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
35 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
36 Turn the selector/key switch to the off
position.
37 Disconnect the platform controls (PCON) from
the platform control cable.
38 Securely install the connector of the GCON
power control harness into the platform
control cable.
39 Working at the platform, securely install the
connector from the platform controls (PCON)
into the platform control cable.
40 Raise the platform and rotate the safety arm
to the stowed position.
41 Turn off all machine power.
To Next Page
Loading...
Need help?
General
