TIRES/RIGGING TRAVEL
IF THE TIRE PUSH BUTTON IS PRESSED ON A CRANE THAT DOES NOT HAVE TIRE
OPTIONS THE MESSAGE “NO OTHER TIRE OPTIONS” WILL APPEAR IN THE
INFORMATION DISPLAY. REFER TO YOUR CRANE RATING MANUAL FOR DETAILS OF
THE OPTIONS ON YOUR CRANE.
• On cranes that have more than one tire option, e.g. static, creep etc., the operator
must select the tire configuration that corresponds to the tire chart to be used.
• Start the choice by pressing the tire push button (item 21).
• The available tire selection options will be displayed in the information screen (item 1).
There can be four options displayed at a time, one next to each selection key.
- If the required option is visible, select the option by pressing the button next to it.
- If more than 4 options are available, a second selection screen can be viewed by
pressing the button next to the "next" label.
- If only a single option is available, it will automatically be selected.
• RIGGING/TRAVEL MODE is selected when the crane is in the rigging process or is a
rough terrain crane traveling between jobs.
RIGGING/TRAVEL MODE is selected when the crane is in the rigging process or
is a rough terrain crane traveling between jobs. ALL CRANE CONTROLS REMAIN
ACTIVE WHILE THE RIGGING/TRAVEL MODE IS SELECTED.
81REVISED:
To Next Page
Loading...
