Pin
The KT-10 v2 is equipped with a PIN for rough surface measurements. To enable the
meter in the PIN mode, PIN must be selected.
Figure 14: PIN mode
Core Diameter
Contains a list of the different core diameter sizes that can be selected; both standard
North American and non-standard diameters are available. When a diameter is selected,
for either full cylindrical or split cores, the diameter correction is automatically applied to
magnetic susceptibility and conductivity measurements.
Figure 15: Core diameter
Concentration (Conc.) Tables (for Plus model only * see page 106)
The user can choose to obtain readings in either basic SI or CGS units, or as a grade
estimate in a percentage (%) for any installed calibration table.
Figure 16: Measure units
22
To Next Page