72 SoundSystem DMX
There is no feedback signal to my ForceFeedback joystick.
For ForceFeedback transmission, MIDI lines are partially used. The DMX should not have
to share the IRQ with other cards. You should also use the current driver software from
Microsoft because older versions can sometimes cause problems.
After installing the ActiveRadiosoftware, I get the message 'Error initializing Hardware'.
This tells you that you have an older version of the ActiveRadio software. Only use the
software that comes with the DMX CD and not the software that comes with the radio
card. Current versions can be obtained online at our Internet site or from our mailbox.
I don't notice the MacroFX effect.
Check the settings in the DMX Mixer. MacroFX operations with a volume increase. If you
set the controller to max., the card cannot increase the volume any further.
To Next Page
Loading...
